
Developed for doctors, the Quasar MD is the most powerful product in the Quasar family. Made specifically for your busy lifestyle, you will enjoy faster results and quicker treatments than any other light-based skin care product. Now available to everyone, the Quasar MD is the answer to all your skin care concerns:
The result? A younger-looking you.
Here’s how it works: The Quasar MD uses proprietary SequePulse technology with four wavelengths of red and infrared light. These wavelengths have been scientifically proven to diminish the appearance of fine lines and wrinkles, enlarged pores and discoloration. Used just once per week, the Quasar MD increases circulaition, resulting in skin that’s smoother, firmer and younger-looking.
So cancel your next doctor or spa appointment, and get powerhouse skin care right in the comfort and privacy of your home.
Get real results in three easy steps:
This device also comes with a 1oz Pure Silk Serum.
Thoroughly clean your face and apply the Pure Silk Serum as per instructions. You may also safely use the Quasar MD with your favorite moisturizer so long as the product does not leave a barrier on the skin which could prevent the light from penetrating. The Quasar MD will increase the effectiveness of the products.
Divide the face into 6 sections as shown in the picture. When starting treatment, you should first use the mode for your skin type. Low Frequency (Orange LED) for sensitive skin or High Frequency (Red LED) for normal skin.
Starting at section A, move the wand slowly over that area for two minutes. Press lightly, only firmly enough to keep the face of the Baby Quasar against the skin. Try not to let light escape as only the light penetrating will have a therapeutic benefit. A soft tone will sound signaling you to move to the next area. Next move clockwise to section B. Slowly move the wand over that area for two minutes. Moving in a clockwise direction, treat each section C, D, E, F. After treating all six sections, continue by repeating the treatment a second time using the Continuous Wave (Green LED) or High Frequency (Red LED). If you have special areas of concern, use the light for another two minutes in those areas on the Continuous Wave (Green LED) strength setting.
Push the button on the back of the wand until indicator light is not shining and LEDs turn off. You are now finished with the treatment. After disconnecting the unit from the power source, clean the equipment per instructions provided in the user manual.
This product can only be shipped to U.S. and Canadian addresses.
There are no restrictions on the delivery of this item - you may elect to have this item sent Next Day, 2 Day, or through our standard delivery method.