pH+ Clarifying Shampoo: The application starts with washing the hair twice with GKhair pH+ Clarifying Shampoo. The clarifying shampoo preps the hair for the Juvexin treatment and removes excess build up and styling products from the hair. Towel dry and brush the hair. Apply "THE BEST" Section the hair in ½-inch each and use the application brush to apply “The Best” on each ½-inch section of hair. DO NOT APPLY ON THE SCALP. Be sure to stay ¼-inch away from the scalp while combing or massaging the product through the hair. Be generous with the strokes as all of the hair needs to be saturated in order for the treatment to have maximum effect. Let sit for 40-60 min. Allow the product to sit on the hair for 40 to 60 minutes. a) 40 minutes for fine, wavy hair. b) 60 minutes for thick, coarse, tight curly hair to maximize the smoothing results. Cover the hair with a plastic cap. Rinse with warm water. Rinse the hair with warm water until the products runs clear out of the hair. If hair is over-processed or red, shampoo the hair with GKhair Moisturizing Shampoo focusing on the ends to remove excess product.

Deep Conditioner: Apply the Deep Conditioner and rinse off after 5 minutes. Blow dry on high heat. Blow dry the hair straight on high heat with a round brush using sufficient tension to smooth the hair until 100% dry. Sealing. Section the hair and flat iron with GKhair Titanium Flat iron at 400 degrees. If the hair is overprocessed, flat-iron at 375 degrees, lower the temperature further if the hair is very weak and damaged; especially towards the ends of the hair. Pass the flat iron about 2-4 times on each section. After. Clients are free to wash their hair at any time after the treatment, using GKhair Shampoos and Conditioners fortified with Juvexin to maintain the results of the treatment. Visit www.GKhair.com for more information.